Not resolved
1 comment

Purshased 26" Craftman Snowblower, 1-8-12.Forward to reverse speed gears function very hard, can't move gears without holding still the blower with two hands.

Checked 3 to 4 smilar models by Craftmans at Sears, all did the same thing. Followed install instruction to adjust, didn't help, and tech agreed.

After a total of 6 calls to Sears-service, parts, customer service, warranty and the store, no one could help, was given no manufactory number to call, and one Tech said he would forward information to manufactory, he, Bob never called back to report findings.Help Please!!!!

Monetary Loss: $900.

Had an Experience with Craftsman?

Write a review

Comments

Terms of Service
Post Comment
Cancel
Anonymous
#420016

they do not make them like they use to in the u.s.a.most new is china or japan junk check where the linkage pivots might be tight or is the clutch engaging enuff since you must sit still with it ?can't tell could be a pilot gear too.wd40?

sorry its one of those gotta have a six pack,and mess around with it till ya find whats going on.and if that doesn't work get your money back if you can buy American good luck !!

You May Also Like